Ulead QUICK DROP 2.0 - VERSION 2006 Wartungshandbuch PDF herunterladen (Seite 158)

158

Scale

Note: the detailed setting possibilities are NOT

available in the smaller Heroglyph "RAPID" Version

Here you can select further options for scaling:

First of all, you have to define how the scaling is to be coupled in its directions:

Horizontally and vertically coupled

this means that all the settings you make have the same effect, both vertically and horizontally.

The result is that all these settings only have to be done once.

Only horizontally

scaling is only active in horizontal direction.

Only vertically

scaling is only active in vertical direction

any

scaling can be defined completely free, separately in any direction and also in its start and end

values.

The following additional settings are also possible:

large<->normal

the objects are scaled down to a percentage of their size (sliding controller or input) starting from

the size set in the layout. The default value for the scaling is always greater than 100%:

small<->normal

the objects are scaled up to a percentage of their size (sliding controller or input) starting from

the size set in the layout. The default value for the scaling is always less than 100%.

any

any start or end value can be entered as a percentage value here. The difference results in the

scaling effect.

If one of the two values should have the same character size as defined in the layout, 100% must

be chosen.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 188 189

Keine Kommentare

Ulead QUICK DROP 2.0 - VERSION 2006 Wartungshandbuch Seite 158