Ulead PYRO1394DV Bedienungsanleitung PDF herunterladen (Seite 4)

PYRO 1394DV INSTALLATION HINTS:

Make sure the driver for the PYRO card has been properly installed in your

Device Manager. Once you installed the PYRO card into your system, Windows

should detect the device and install the drivers for Texas Instrument OHCI

Compliant IEEE 1394 Host Controller. Please refer to the Users Manual. Go to

the Device Manager (right click My Computer, select Properties and select the

Device Manager tab) and you should see the device listed there.

If you are using a Sony DV Camcorder and the Camcorder is not being

detected in Windows 98, please set the 1394 Host Controller to Support Non-

compliant devices. Go to the Device Manager, select the 1394 Bus Controller

and double click the Texas Instrument OHCI Compliant IEEE 1394 Host Con-

troller. You will get the Properties for the Texas Instrument OHCI Host Control-

ler device, please click on the Settings tab and then put a check on the box for

Support Non-Compliant Devices. Once this is checked, click the OK button and

try connecting the Sony DV Camcorder to the PYRO card once again and then

check for the 1394 DV Camcorders in your Sound Video and Game Controllers

category.

Please make sure the drivers for the DV Camcorder are installed correctly. Go

to your device manager and click the Sound Video and Game Controllers cat-

egory and make sure that the 1394 DV Camcorder is listed whenever the DV

camcorder is connected to the PYRO card. Remember to switch the DV Cam-

corder to VTR mode.

Camcorder must be turned on and connected to a 1394 port for it to appear in

the device manager as 1394DV Camcorder.

With Ulead running, do the following settings, click the Global command but-

ton, select Change Capture Plug-in and select Ulead DirectShow capture plug-

in, click OK, click on Select Device Control and set the current device to TI 1394

Device control.

1 2 3 4 5 6 7 8 9 ... 12 13

Keine Kommentare

Ulead PYRO1394DV Bedienungsanleitung Seite 4